Whats
Happening! |
- The "official" Tuesday work sessions have been suspended
for the summer so that this diligent and talented crew can have the
summer with their families and other hobbies. No doubt though, many
will work at home on parts of the Futurliner. Just can’t keep these
guys away from the project!
- Bendix
has offered to supply parts required to rebuild the
complete brake systems. Thanks to the efforts of Jeff Miller for
these contacts and all his work. Chuck Eberling at Bendix is our
contact. Parts should start arriving this summer and assembly will start
this fall. This is the only part of the vehicle not being restored to
the original design for obvious safety reasons.
- Major accomplishments
on the vehicle include:
- The rebuilt engine has been delivered by Bill Bicknell and
is ready for installation. (more details below)
- Drivetrain
– All the components are restored and on site. The
front axle, rear axle, differential, rear transmission and drive shaft
are all complete and installed. The engine and Hydramatic
transmission are sitting in crates and ready for installation when
the groups starts again in Sept. The driveshaft for the PTO is
restored but not yet delivered.
- The wiring is starting to be developed by Jeff Dornbush.
- The cockpit upper section still requires major metal work but the
lower section is all structurally in place. Once the top is completed,
then the sheet metal skin can be installed. Wally Snow is
repairing all the metal around the top windshield framework while Dick
Saddler continues to work on the inside of the cockpit including
the top hatch.
- The large aluminum grill has been repaired by Ryan DeVries and
is being completed and polished.
- One of the jobs to be started this fall is the reconstruction of the
lower stage doors. These doors are 16’ long and are rusted
badly. We have borrowed a car body turnover unit to mount one door at
a time to work on them.
- Sandblasting
of the body is pretty much completed. This proved
to be no small task, especially in the winter and was done mostly
on-site by Del Carpenter and Don.
- GM Powertrain Div.
completed and shipped back the rebuilt
military type Hydramatic transmission.
- As we have mentioned, Bill Bicknell has completed the engine
rebuild that was more than just routine. Though the engine removed
from our vehicle appeared to be a replacement with few miles, he
started with an NOS short block. Bill completely disassembled it,
cleaned it out (many chips were still in it) and started from there.
Unfortunately, the engine from our vehicle was a commercial type
rather than the original military type so numerous parts had to be
obtained including engine mounts, accessories, electric fuel pump,
distributor, etc. These all had to be restored and rebuilt so our
engine can be as it was in 1953 for the start of the Parade of
Progress. This is the GMC 302 cu. in in-line 6 cylinder engine. The
parts Bill needed were obtained from all over including Florida,
California, NC, Missouri, Ohio, Michigan and Canada thanks to the big
following this project has generated around the country.
- Two additional carburetors have been obtained and one will be
rebuilt by Dean Tryon as a spare. The second will be used for
parts since it is missing the throttle linkage. Both are the governor
types.
- The air cleaner has been restored and painted by Stu Allen in
Clio Michigan.
- Our continued appreciation to the Inliners International Group for
all the information and parts their members have supplied on the
Futurliner engine. Their web site is "www.inliners.com" if
you would like to learn more about them.
- The portable display that Mike Ball has developed has been
used many times this winter and spring. It has proven invaluable in
sharing the project status with others and has resulted in numerous
people coming forth with information, parts, donations or services.
|
NATM
Visit to
Zeeland –
5/12/01 |
Over 50 people from the National Automotive and Truck Museum of the
United States made their annual visit via a chartered bus to the Zeeland
work site where the Futurliner is being restored. The volunteers showed
up by car (both antique and modern). Bill Bicknell pointed out an
interesting fact - in 1953, the first showing of the Parade of Progress
after World War II occurred on May 12, 1953 exactly 48 years ago that
day. Highlights include:
- Bill Bicknell
our engine builder volunteer was here showing us
pictures of the rebuilt Futurliner engine sitting on his test stand in
Enon, Ohio (near Dayton) and running. The engine has since been
running for over 4 hours and looks good.
- Joel Dirnberger came from Monicello, Minnesota and brought
along the 1:24 scale Futurliner model that he is working on. He has
the body done and continues to work on all the attachments. It looks
great.
- Mike Ball had his portable display set up for all to view.
In addition he set up the slide projector and many took the time to
go through slides taken in the 1950's of the Parade of Progress as
well as the Futurliners. These slides came from the PARADERS.
- Almost all of our volunteers that work on the Futurliner were
present. In fact to show the dedication of our volunteers Wally
and Audrey Snow were present as they were celebrating their 29th
wedding anniversary. Congratulations Wally and Audrey.
- John Weller, his wife and son were present. Weller Truck
has restored most of the major running gear on the Futurliner
including axles, brakes, differential etc. A big thank you to John
and his company.
- After reviewing the work progress everyone headed for Jerry's
Country Inn for lunch followed by a short program. Linda DeVries
had made as a donation to our project a leaded stained glass
Futurliner. Ed DeVries volunteered to auction off this
donation to raise funds for the project. Ed managed to raise $700
for the leaded stained glass Futurliner. GREAT JOB ED! We also want
to thank TONY BECKER for making the high bid and all the
folks from NATM who made cash donations at the work site for the
Futurliner Restoration project.
|
History |
- We finally have determined the original engine color per an
e-mail from Ed Harben. "Engines and transmissions for
the military were painted a military green as were the
Futurliners" he reports. Ed was one of the original vehicle
maintenance members.
|
Other
Volunteers |
- Steve Cordes
volunteered to
take the wheels, dismount the tires, sandblast and paint them. He was
visiting with the Tin Can Tourist group in May.
- Jeff Dornbush
recently joined the band of Tuesday volunteers.
- Steve Carpenter
(owner of Grand Northern Products) donated 650 #
of aluminum oxide for sandblasting the unit.
- Montana Paints
thru Wyrick Products continues to supply
all the paint products.
|
Project
Needs |
- We have determined that the original distributor has a part
#1112300 so if anyone runs across one, let us know. Spares are
always needed. David Doyle has been extremely helpful in
finding some of these parts for us.
- We are working with a major steel producer to supply the top
material. And we’re working with 3 other firms in our quest to
find a volunteer organization to fabricate a new top structure.
- We also are still looking for someone to rebuild the generator
and its control box. It will most likely take a company that
works on large industrial motors.
- We have located a source to make new hubcaps to match the
one original we have but at a cost. Would be nice to find someone
who can make them as a donation to the project.
|
Paraders |
- We received the name of another Parader from Jim Miller –
John Bradfield, 323 Bearcamp Rd., South Tamworth, NH, 03883.
- At a recent AACA car show in Grand Rapids, Mike Ball had his
portable display set up again. Art and Donna Takkinen stopped
and mentioned that his uncle, Elmer Takkinen, worked on the
1936-37 Parade. After he passed away, they came across a trunk which
had all of his material he had saved from that time. When they saw
Mike’s display, they decided to donate all the material to the
project. It includes 1" of written material, letters,
bulletins, list of places visited and instruction s for the
Paraders. This is a rare addition to the historical file the project
is collecting.
|
Financial
Status |
- For those of you who cannot work in Zeeland or at your home on the
project, the opportunity to support it financially is certainly
appreciated. Although there are many services and parts donated, a
significant amount of parts and services must be purchased. Any help
here is greatly appreciated.
|
Misc.
Notes |
- The project continues to attract numerous organizations for a visit
to Zeeland. In June, the VMCCA’s 1 & 2-cyl car tour
stopped with 26 cars. The Coopersville (Michigan) Museum and
their supporters toured also in June. In May, the Tin Can Tourist
group visited Zeeland following their annual get together in central
Michigan. In April, 32 members of the Flint, Michigan AACA
visited and presented a cash donation to the project.
- The restoration project was mentioned again in the June 14 issue of Old
Cars Weekly and specifically picked up on the point in a recent
newsletter about the running lights that were used (and modified) from
early 40-‘s GM vehicles.
|
Status
of
Other
Futurliners |
- We received a note and photos from Chris Contes (GM Proving
Grounds – Mesa Arizona) with info and 6 photos of 2 Futurliners in a
wrecking yard near Phoenix in 1997. These 2 were subsequently sold to Brad
Boyajian and Mike Kadletz. More recent photos of both are
on our web site.
- The Peter Pan restored Futurliner was featured in a Memorial
Day event sponsored by Peter Pan along with 60 converted coaches. Jim
Stacy wrote that he had the opportunity to view and ride in it.
They are using a new 4-71 Detroit Diesel turbocharged engine.
|